Product Comparison
Waterproof housing tutorial
-
-
Before using waterproof housing
- Carry out a waterproof test before using the waterproof case to ensure that the waterproof case is waterproof and then install it to the camera.
- 1. Check if the waterproof case has physical damages such as scratch and if there are foreign matters or dusts on the rubber gasket; clean up all parts of the waterproof case.
- 2. Close the waterproof case to assure complete engagement, and then put it 10-30cm below the water to test for 10-15min.
- 3. Take the waterproof case out, remove the drops of water outside the case, and then wipe all outer parts with tissues to make sure that the case has been totally dried before opening it to check if it is waterproof.
- 4. If the waterproof case fails the test, please contact the seller for replacement request immediately.
-
- After the test, please pay attention to the following tips:
- 1.When using the ONE in a low-temperature environment, it’s best to use anti-fog inserts along with the waterproof housing to prevent condensation from affecting your shots.
- 2.When in an environment where water- and dust-proofing aren’t necessary, it’s best to use the ONE without a housing.
-
Before capturing
- 1. Before using waterproof housing for shooting, please open ONE App -> tap 'Setting' -> tap 'Calibrate stitching', and then follow the steps:
- 2. After capturing, open file(s) taken with waterproof housing, tap 'MORE' at the top right corner -> tap 'Stitch for waterproof case', and then follow the instructions shown in the App.
After capturing
Was this information helpful?
Yes
No
%20(1).svg)
%20(1).svg)
.svg)
